O-Atty X
Odis Design have just announced the imminent release of their latest RDA, tentatively scheduled for release on the 1st June...
-
by Dan Willis
Share on:
The O-Atty X follows the massively popular O-Atty and it's successor, the O-Atty V2, both of which were top selling RDAs over the past couple of years.
Odis have revamped the build deck with the O-Atty X, offering the same two post clamp system as found with its predecessors, but it's looking like the clamps and screws have been beefed up for extra stability. Four cut outs are found on the edge of the deck to rest your coiling rod in, and these offer the ability to place your coil in line with the airflow or at an angle.
On the top cap, the recognisable teardrop shaped airflow holes are still present, however a channel is cut out above each airflow hole- Odis have remained tight lipped on the function of this but it will be interesting to find out the purpose of these channels!
A 510 pin and bottom feed pin for squonking will be included with the O-Atty X, and on its imminent release stock should be widely available- no lists or secret handshakes will be required for this atty!
I am a huge fan of the original O-Atty, so I'm really looking forward to seeing what the O-Atty X brings to the table, and of course a full review will be on POTV shortly!
Photo Credit:
IMAGES TAKEN FROM THE ODIS DESIGN FACEBOOK PAGE
Dan Willis
Journalist at POTVDan was an early adopter of vaping as a way to quit smoking and has seen and done pretty much all there is to see and do in the vaping world! From Ego batteries to mechs and from rebuildables to pods there isn't much that Dan hasn't tried.
